Suspension Inspection; Supporting Your Vehicle For Service - Ford F-750 Owner's Manual

SUSPENSION INSPECTION

Note: Do not adjust air suspension height to any setting other than the
specified setting. Altering the height setting will change the driveline
angle and may result in unwarrantable component damage, such as
transmission component damage.
Verify drive axle air suspension height and height control valve
performance at engine lube oil change intervals.
Periodically:
• Check condition of spring leaves for evidence of fatigue, bending or
breakage.
• Check condition of suspension mounting brackets and bushings.
• Check that torque rod mounting fasteners are tight.
• Check to be sure the suspension alignment is maintained at all times.
• Check U-bolts after the chassis has been operating under load for
1,000 miles (1,600 km) or six months, whichever comes first, the
U-Bolt nuts must be re-torqued. The U-Bolt nuts thereafter must be
re-torqued every 36,000 miles (58,000 km). The U-Bolt and nut
threads and seats should be cleaned and lubricated to ensure a "like
new" condition when re-torquing.
Note: See the U-Bolt Nut Torque chart later in this section.

Supporting your vehicle for service

When performing service repairs on your vehicle, first prepare the
vehicle by doing the following:
1. Park the vehicle on a level concrete floor.
2. Set the parking brake and block the wheels to prevent the vehicle
from moving.
3. Select a jack with a rated capacity sufficient to lift and hold up the vehicle.
4. Raise the vehicle with the jack applied to the axle(s). DO NOT use the
bumper as a lifting point.
5. Support the vehicle with floor stands under the axle(s). If the axle or
the suspension are being serviced, support the vehicle with floor stands
under the frame side-members, preferably between the axles.
Do not use a jack when working under a vehicle. It may give way,
causing the vehicle to fall and result in property damage, personal
injury or death. Always use floor stands to support the vehicle.
2007 F-650/750 (f67)
Supplement (supplement)
Canadian_French (fr_can)
Maintenance and Specifications
201