Honda CRF250X Owner's Manual & Competition Handbook page 65

250X_030-059.qxd 08.7.14 14:29 ページ59
5. Install the clutch pressure plate (7).
6. Install the five clutch springs and clutch
spring bolts (8).
7. Tighten the bolts in a crisscross pattern in two
or three steps to the specified torque:
12 N·m (1.2 kgf·m, 9 lbf·ft)
(7)
(7) clutch pressure plate
(8) clutch spring bolts/clutch springs
8. Install a new O-ring (9) in the groove of the
clutch cover (10).
9. Install the clutch cover by tightening the
clutch cover bolts to the specified torque:
10 N·m (1.0 kgf·m, 7 lbf·ft)
(9)
(10)
(9) O-ring (10) clutch cover
10.Apply grease to the rear brake pedal pivot bolt
sliding surface.
11. Install the rear brake pedal (11), dust seals
(12), washer (13) and pivot bolt (14) and
tighten the pivot bolt to the specified torque:
36 N·m (3.7 kgf·m, 27 lbf·ft)
Connect the brake pedal return spring (15) if
it was removed.
12. Insert the pin (16).
(8)
(16)
(15) (13)
(12)
(11) rear brake pedal (14) pivot bolt
(12) dust seals (15) return spring
(13) washer (16) pin
13. Fill the crankcase with transmission oil
(page 47).
Clutch System
(11)
(14)
Servicing Your Honda
59