Additional Maintenance Procedures - Honda CRF250X Owner's Manual & Competition Handbook

250X_084-103.qxd 08.7.3 10:13 ページ97
Refer to Safety Precautions on page 25.
Steering Head Bearing Inspection
1. With your CRF on a box or optional
workstand (front wheel elevated), turn the
handlebar to the right and left to check for
roughness in the steering head bearings.
2. Stand in front of your CRF, grab the fork (at
the axle), look at the steering head, and push
the fork in and out (toward the engine) to
check for play in the steering head bearings.
If any roughness or play is felt, but you do
not see any movement in the steering head,
the fork bushings may be worn. Refer to the
Honda Shop Manual for replacement or
adjustment procedures, or see your Honda
dealer.

Additional Maintenance Procedures

Handlebar Inspection
1. Check the handlebar (1) for bends or cracks.
2. Check that the handlebar has not moved from
its proper position by inspecting the paint
mark (2).
3. Check the torque of the handlbar upper holder
bolts (3):
22 N·m (2.2 kgf·m, 16 lbf·ft)
Tighten the front bolts first.
(3)
(2)
(1) handlebar (3) handlebar upper holder bolts
(2) paint mark
Control Cables
Periodically, disconnect the throttle, clutch and
hot start cables at their upper ends. Thoroughly
lubricate the cable pivot points with a
commercially available cable lubricant. If the
clutch lever, hot start lever and throttle do not
operate smoothly, replace the cables.
Be sure the throttle returns freely and
automatically from fully open to fully closed, in
all steering positions.
(1)
Servicing Your Honda
97