Yamaha RX-V663 Owner's Manual page 106

Troubleshooting
After AUTO SETUP
Warning message
W-1:OUT OF PHASE
W-2:OVER 24m (80ft)
W-3:LEVEL ERROR
W-4:CHECK PRNS
Notes
• If the "ERROR" or "WARNING" screens appears, check the cause of the problem, then run "AUTO SETUP" again.
• If a warning message "W-1", "W-2", or "W-3" appears, corrections are made, but they may not be optimal.
• If an error message "E-10" occurs repeatedly, contact a qualified Yamaha service center.
104
En
Cause
Speaker polarity is not correct. This message
may appear depending on the speakers even
when the speakers are connected correctly.
The distance between the speaker and the
listening position is over 24 m (80 ft).
The difference of volume level among
speakers is excessive.
"EXTRA SP ASSIGN" is set to
"PRESENCE", though the presence channel
signals are not detected.
Remedy
Check the speaker connections for proper
polarity (+ or –).
Bring the speaker closer to the listening
position.
Readjust the speaker installation so that all
speakers are set in locations with similar
conditions.
Check the speaker connections.
Use speakers of similar quality.
When "SWFR: TOO LOUD"or "SWFR:
TOO LOW" appears in the result screen, the
output volume of the subwoofer.
Check the presence speaker connections.
Set "EXTRA SP ASSIGN" to a setting other
than "PRESENCE".
See
page
14
—
—
14
—
32
14
33