Table of Contents
Advertisement
7. Position the new memory module over the memory slot. Make sure that the
Figure 14. Installing the memory module
8. Reinstall any parts and reconnect any cables that have been removed.
Replacing the power supply assembly
This section provides instructions on how to replace the power supply assembly.
To replace the power supply assembly, do the following:
1. Remove the computer cover. See "Removing the computer cover" on page 14.
2. Disconnect the power supply assembly cables from the system board and all
22
User Guide
notch 1 of the new memory module is aligned with the slot key 2 of the
memory slot. Then, press the new memory module straight down into the
memory slot until the retaining clips close and the new memory module snaps
into position.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the installation or replacement, go to "Completing the parts
replacement" on page 35.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
drives. See "Locating parts on the system board" on page 10.
Advertisement
Table of Contents
