Lighting The Side Burner - Brinkmann Elite Owner's Manual

MATCH LIGHTING THE MAIN BURNERS:
1. Open lid before lighting.
2. Turn the burner control knobs to " " (OFF).
3. Place a paper match in the end of the matchlighter. Strike the match and place
through lighting hole in the left hand side of the grill to approximately 1 to 2
centimeters from the burner.
4. Turn on the FAR LEFT burner control knob to the " " (HIGH) position.
The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to " " (OFF) and wait 5
minutes to allow gas to dissipate and repeat lighting procedure.
6. To light other burners, push and turn control knobs to " " (HIGH) in sequence
from left to right.
7. If the burner does not light within the fi rst few attempts of match lighting, there is a problem with the gas
supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem
is found and corrected.
Note: If burner does not light or fl ame is too low, See "Trouble Shooting" section of the owners manual.

LIGHTING THE SIDE BURNER:

1. Open lid before lighting side burner.
2. Make sure control knob is in the " " (OFF) position.
3. Push and hold down the SIDE BURNER control knob and turn SLOWLY
(2 to 3 seconds) to " " (HIGH). You should hear the igniter click.
Note: Step 3 may need to be repeated 2-3 times to light grill.
4. If ignition does NOT occur in 5 seconds, turn control knob to " " (OFF),
wait 5 minutes to allow gas to dissipate and repeat lighting procedure.
5. If burner does not ignite using the igniter, see "Match Lighting the Side
Burner" section.
6. To turn off, turn each control knob clockwise until it locks in the " " (OFF) position. This does not turn
off the gas fl ow from the cylinder.
Note: If burner does not light or fl ame is too low, See "Trouble Shooting" section of the owners manual.
MATCH LIGHTING THE SIDE BURNER:
1. Open the lid to the side burner before lighting.
2. Turn the burner control knob to " " (OFF).
3. Strike and carefully place a match approximately 1 to 2 centimeters from the burner.
4. Turn the side burner control knob to the " " (HIGH) position. The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to " " (OFF) and wait 5 minutes to allow gas to
dissipate and repeat lighting procedure.
6. If the burner does not light within the fi rst few attempts of match lighting, there is a problem with the gas
supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem
is found and corrected.
Note: If burner does not light or fl ame is too low, See "Trouble Shooting" section of the owners manual.
LIGHTING THE SEAR BURNER:
1. Open the lid to the sear burner before lighting.
2. Make sure control knob is in the " " (OFF) positi on.
3. Push and hold down the SEAR BURNER control knob and turn SLOWLY
(2 to 3 seconds) to " " (HIGH). You should hear the igniter click.
Note: Step 3 may need to be repeated 2-3 times to light grill.
4. If ignition does NOT occur in 5 seconds, turn control knob to " " (OFF),
wait 5 minutes to allow gas to dissipate and repeat lighting procedure.
5. If burner does not ignite using the igniter, see
"Match Lighting the Sear Burner" section.
9
Lighting Hole
Matchlighter