6. Repeat steps 3–5 for lighting each burner. Always use electronic igniter for lighting each burner. If
burner does not ignite using the push-button igniter, see "Match Lighting the Main Burners" section .
7 . To turn off, turn each control knob clockwise until it locks in the "OFF" position . This does not turn off
the gas flow from the cylinder.
Note: I f burner does not light or flame is too low, See "Trouble Shooting" section of the owners manual.
MATCH LIGHTING THE MAIN BURNERS:
1 . Open lid before lighting burner .
2 . Make sure all control knobs are in the "OFF" position .
3 . Place a paper match in the end of the matchlighter . Strike the match and
place through lighting hole in the left hand side of the grill to approximately
1/2" (1 to 2 cm) from the burner.
4 . Turn on the FAR LEFT burner control knob to the "HIGH" position . The
burner should light within 5 seconds .
5 . If the burner does not light, turn the control knob to "OFF" and wait
5 minutes for gas to dissipate and repeat lighting procedure .
6 . Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the "HIGH"
position .
7 . If the burner does not light within the first few attempts of match lighting, there is a problem with the
gas supply . Turn off the gas at the burner and cylinder . DO NOT attempt to operate the grill until the
problem is found and corrected .
Note: I f burner does not light or flame is too low, See "Trouble Shooting" section of the owners manual.
LIGHTING THE SIDE BURNER:
1 . Open lid before lighting side burner .
2 . Make sure control knob is in the "OFF" position .
3 . Push and turn side burner control knob to the "HIGH" position .
4 . Press the electronic igniter on the main control panel and hold for
3–5 seconds to light burner.
5 . If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait
5 minutes to allow gas to dissipate and repeat lighting procedure .
6 . To turn off, turn each control knob clockwise until it locks in the "OFF"
position .
Note: I f burner does not light or flame is too low, See "Trouble Shooting" section of the owners manual.
MATCH LIGHTING THE SIDE BURNER:
1 . Open lid before lighting side burner .
2 . Make sure control knob is in the "OFF" position .
3. Strike the match and place it approximately 1/2" (1 to 2 cm) from the burner.
4 . Push and turn the side burner control knob to the "HIGH" position . The burner should light within 5
seconds .
5 . If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and
repeat lighting procedure .
6 . If the burner does not light within the first few attempts of match lighting, there is a problem with the gas
supply . Turn off the gas at the burner and cylinder . DO NOT attempt to operate the side burner until the
problem is found and corrected .
Note: I f burner does not light or flame is too low, See "Trouble Shooting" section of the owners manual.
Lighting
Hole
Matchlighter
10