Briggs & Stratton 120000 Operator's Manual page 14

Maintenance
How To Access The Spark Plug
(1-Piece Snow Hood)
To access the spark plug, the snow hood must be removed
as follows:
1. Remove the safety key (A). Keep the safety key out of
reach of children. See Figure 14.
2. Grasp the choke control knob (B) and pull up to remove.
3. Remove the mounting screws (C).
4. Carefully remove the snow hood (D). Do not disconnect
the primer hose (E) or the stop switch wire (F)
(Figure 15).
5. The spark plug (G) can now be accessed.
6. Before installation of the snow hood, make sure that the
primer hose and the stop switch wire are connected.
7. Mount the snow hood to the engine and secure with the
mounting screws (Figure 14).
8. Install the choke control knob onto the choke shaft (I).
9. Do not install the safety key until you are ready to start
the engine.
14
B
I
A
C
Figure 14
G
E
D
Figure 15
C
F
BRIGGSandSTRATTON.COM