Briggs & Stratton 120000 Operator's Manual page 13

How To Access The Spark Plug
(2-Piece Snow Hood)
To access the spark plug, the snow hood must be removed
as follows:
1. Remove the safety key (A). Keep the safety key out of
reach of children. See Figure 12.
2. Grasp the choke control knob (B) and pull up to remove.
3. Remove the mounting screws (C, Figure 13).
4. Carefully remove the top part of the snow hood (D). Do
not disconnect the primer hose (E) or the stop switch
wire (F).
5. The spark plug (G) can now be accessed.
6. Before installation of the snow hood, make sure that the
primer hose and the stop switch wire are connected.
7. Mount the top part of the snow hood to the snow hood
base (H). Make sure the top interlocks with the base.
Secure with the mounting screws.
8. Align the slots in the choke control knob with the tabs on
the choke shaft (I) and then push down to install. If the
knob is not installed correctly, the choke will not operate.
9. Do not install the safety key until you are ready to start
the engine.
en
B
Figure 12
D
G
E
H
Figure 13
Maintenance
A
C
F
I
13