BT PARAGON 400 User Manual page 17

When your answering machine is switched on,
the pre-recorded message will automatically
greet callers with:
"Hello, your call cannot be taken at the moment,
so please leave your message after the tone."
Callers can skip this message by pressing
start recording after the tone.
You can replace this message with your own
personal outgoing message. The pre-recorded
message remains in the memory and you can
always choose to use it again.
If your answering machine is switched to Answer
Only your outgoing message is: "Hello, your call
cannot be taken at the moment and you can not
leave a message so please call later."
The pre-recorded Answer Only announcement
will also be played if there is not enough
recording capacity left for callers to leave their
14
message.
Press buttons in the order shown
Press until the display shows
Menu
OUTGOING MESSAGE.
Dial /OK
and
Outgoing message is played.
Play
Press either to switch between a male
or female voice for your OGM.
Press until the display shows
Menu
OUTGOING MESSAGE.
Display shows MAIN MESSAGE.
Dial /OK
To select between MAIN MESSAGE,
MAILBOX 2 and MAILBOX 3.
To select the displayed option. The
Dial /OK
prompt says "Please speak after the tone.
To end recording press OK". The display
shows recording and counts up.
Start speaking your Outgoing message.
You can also at this point lift the handset
Dial /OK
and record you message through the
handset.
To stop recording. Your new Outgoing
message is played back. To delete the
recording, press during playback.
DEL