If you use your Paragon 400 as a desk phone
you will need to fit the stand on to the base.
Ensure all the cables on the underside of the
base are in their respective channels.
Proceed by holding the stand as shown in the
illustration, ensuring the two arrows are facing
each other.
Now lower the stand so that the two lugs
nearest to you, fit into the corresponding holes
on base, as shown.
Push and squeeze until the stand clicks into
place from front and back as shown in the inset.
8
Turn around the handset clip to prevent the
handset from falling when the product is
wall-mounted.
Use the template on page 25 to drill holes in
the wall. Leave a small gap between the screw
heads and the wall.
ARROWS
Place your Paragon 400 over the screw heads
and slide down.
WALL
SCREW
WALL PLUG
WALL
DESK