Yamaha Drag Star XVS125 Owner's Manual page 42

1. Oil filter element
2. O-ring
5. Remove and replace the oil filter
element and O-ring.
6. Install the oil filter element cover
by installing the bolts, then tight-
ening them to the specified
torque.
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m0kgf)
NOTE:
Make sure that the O-ring is properly
seated.
PERIODIC MAINTENANCE AND MINOR REPAIR
7. Install the engine oil drain bolt,
and then tighten it to the speci-
2
fied torque.
1
Tightening torque:
Engine oil drain bolt:
34 Nm (3.4 m0kgf)
8. Add the specified amount of the
recommended engine oil, and
then install and tighten the oil
filler cap.
cC
6-11
Recommended engine oil:
See page 8-1.
Oil quantity:
With oil filter element
replacement:
1.6 L
Without oil filter element
replacement:
1.4 L
Total amount (dry engine):
1.75 L
8 In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives
with the oil or use oils of grade
"CD" or higher. In addition, do
not use oils labeled "ENERGY
CONSERVING II" or higher.
8 Make sure that no foreign
material enters the crankcase.
ECA00105
6