4. Procedure For Measurement Of "Co" Emission Level - Yamaha Crux Owner's Manual
Hide thumbs
Also See for Crux:
- Owner's manual (158 pages) ,
- Workshop manual (209 pages) ,
- Owner's manual (22 pages)
Table of Contents
Advertisement
'CO' EMISSION LEVEL MEASUREMENT
4. PROCEDURE FOR MEASUREMENT OF "CO" EMISSION LEVEL
4.1
IMPORTANT : "CO" Measurement Equipment must be duly calibrated.
4.2
Check for "NO LEAKAGE" from Exhaust System.
4.3
Starter Lever should be in OFF position.
4.4
All Electricals should be in OFF position.
4.5
Set the Idle speed of the Engine in warmed up condition of Motorcycle as specified.
MODEL
CRUX
4.6
Insert the Sampling probe of the Exhaust Gas Analyser inside the Exhaust Muffler of the
Motorcycle.
4.7
• If the reading is within specified limits then it is acceptable.
• If the reading exceeds the norm of 3.5% (by volume) have it adjusted by YMIS Authorised
Dealer.
4.8
YMIS serves you through an extensive network of
•
•
•
greenbook.pmd
IDLE R.P.M.
1300 - 1500 RPM
Authorised Dealers
Authorised Service Points.
Trained Private Workshop (Garage) Owner's.
6
4
9/24/2005, 8:00 AM
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
