Belkin F5D7230-4 User Manual page 6

KNOWING YOUR BELKIN ROUTER
(6) (7)
6. Power Jack
Connect the included 5V DC power supply to this jack.
7. LAN Ports
The LAN ports are RJ45, 10/100 auto-negotiation, auto-uplinking ports for
standard UTP category 5 or 6 Ethernet cable. The ports are labeled 1 through 4.
These ports correspond to the numbered LEDs on the front of the Router.
8. Internet/WAN Port
This port is for connection to your cable or DSL modem. Use the cable that was
provided with the modem to connect the modem to this port. Use of a cable
other than the cable supplied with the cable modem may not work properly.
(8) (9)
8
KNOWING YOUR BELKIN ROUTER
9. Reset Button
The "Reset" button is used in rare cases when the Router may function
improperly. Resetting the Router will restore the Router's normal operation while
maintaining the programmed settings. You can also restore the factory default
settings by using the Reset button. Use the restore option in instances where
you may have forgotten your custom password.
a. Resetting the Router
Push and release the Reset button. The lights on the Router will
momentarily flash. The Power/Ready light will begin to blink. When the
Power/Ready light becomes solid again, the reset is complete.
b. Restoring the Factory Defaults
Press and hold the Reset button for five seconds then release it. The
lights on the Router will momentarily flash. The Power/Ready light will
begin to blink. When the Power/Ready light becomes solid again, the
restore is complete.
9