Installation - Alpine DVE-5207 Owner's Manual

Installation

Check accessory parts.
RCA-extension RCA-extension
cable (for video cable (for audio
signal 2m) signal 2m)
x 1
1 Bracket
Battery (CR2025)
x 1 (1 each left and right)
3 Screw with 4 Hex bolt (M6 × 50)
double washer
(M5 × 10)
x 4
6 Spring washer 7 Flanged head hex
(M6) nut (M6)
x 4
9 Velcro fastener ! Mounting sleeve
x 2
# Front frame $ Hex nut (M5)
x 1
( Hex bolt (M5 × 7)
& Rubber cap
x 1
Remote control
x 1 x 1
2 Floor base
x 2
5 Flanged self-
tapping screw
(M5 × 15)
x 4 x 4
8 Wing nut (M6)
x 4 x 4
" Flat head screw
(M5 × 8)
x 1 x 4
% Bolt stud
x 1 x 1
x 1
Installation Location
Before deciding on the mounting location, check that opening and
closing the display will not hamper the gear shift in any position.
• Install at an angle of within 35 degrees from the horizontal.
Do not mount the unit in a location of extreme temperature
fluctuations (such as near an air conditioner or heater vent). Disc
read failures or other problems may result.
If mounted in such location, failures such as "Disc can not read." or
other failure may occur.
When installing into the dash board
Caution for installation
Be sure to remove the mounting sleeve squarely from the product,
refer to "Removal" (page 30).
Mounting sleeve !
1
(Included)
DVE-5207
• Remove the wrapping from the unit.
2
Bracket
Dashboard
Mounting sleeve !
Slide the mounting sleeve into the dashboard and fix it with the
metal shackles.
Dashboard
Rubber cap &
Hex bolt (
DVE-5207
Continued
29
-EN