Alpine DVE-5207 Owner's Manual page 31

3
Hex nut (M5) $
Metal
mounting
strap
Ground lead
Reinforce the unit with the metal mounting strap (not supplied).
Secure the ground lead of the unit to a clean metal spot using
a screw *
1 already attached to the vehicle's chassis.
• For the screw marked *
2
, use an appropriate screw for the chosen
mounting location.
Connect each input lead coming from an amplifier or equalizer
to the corresponding output lead coming from the left rear of
the DVE-5207. Connect all other leads of the DVE-5207
according to details described in the "Connections" section.
4
Lock pin
Slide the DVE-5207 into the dashboard. When the unit is in
place, make sure the locking pins are fully seated in the down
position. This can be done by pressing firmly in on the unit
while pushing the locking pin down with a small screwdriver.
This ensures that the unit is properly locked and will not
accidentally come out from the dashboard. Install the
Detachable Front Panel.
Removal
1 Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see above drawing). As
each pin is unlocked, gently pull out on the unit to make
sure it does not re-lock before unlocking the second pin.
2 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Head unit
Ground lead
* 3
Mounting bracket
• Secure the ground lead of the unit to a clean metal spot using a
screw* 3 already attached to the vehicle's chassis.
30
-EN
Screw
*
2
Bolt stud %
*
1
DVE-5207
Chassis
Front frame #
Screws (M5 × 8) (Included
with the head unit)
Flat head screws "
(M5 × 8)
DVE-5207
When mounting using Velcro fastener
1
Place Velcro fastener 9.
Attach two pieces of Velcro fastener 9 with the rough
side facing toward the DVD unit.
2
Put on two pieces of Velcro fastener 9 on the
mounting positions.
Put on two pieces of the Velcro fastener (soft one) 9 on
the mounting positions and mount the unit.
9 Velcro fastener
When mounting to the rear deck
1
Mount the brackets 1 on the unit.
Mount the brackets 1 at both sides of the unit with
screws with double washer (M5 × 10) 3.
3
(Bottom side)
2
Attach the unit to the rear deck.
Attach the unit securely with hex bolts (M6 × 50) 4,
flanged head hex nut (M6) 7, spring washers (M6) 6,
and wing nuts (M6) 8.
When mounting the unit directly on the floor
1
Mount the brackets 1 on the unit.
Mount the brackets 1 at both sides of the unit with
screws with double washer (M5 × 10) 3.
3
1
Floor
1
3
4
7
6
8
3