iDect X1 User Manual page 27

Color profile: Generic CMYK printer profile
Composite Default screen
Troubleshooting
Using a multi-handset system
"I can't transfer Make sure the other handset is in range of the base unit.
a call."
Make sure you're dialling the correct number for the
other handset (1 to 6, or Ø for all registered handsets).
Batteries
"The handset's Before you first used the handset, you should have left it
batteries are on the base unit or charger pod for up to 15 hours to
charge the batteries fully.
running low
within an
You may need to replace the batteries (see below).
hour or two."
Clean the battery charging contacts on the base unit
with a dry cloth.
Check the connections between the base unit and the
mains power socket.
"I try to You need to replace the batteries. To find out how to
recharge the obtain replacements, call 0845 345 9677, between
batteries, but I 9.00 am and 5.00 pm, Monday to Friday.
still get a
Dispose of used batteries safely — never burn them,
warning that
or put them where they could get punctured.
they are low."
ALWAYS use the batteries supplied with your
iDECT X1 — other batteries may burst, causing damage.
PBX use
"The Recall You may need to change the recall signal length from
its default of 100 ms. Consult your PBX documentation
function doesn't
for help if necessary. To change the recall setting, use
seem to work."
BASE SETTING
the menu (page 37).
46
E:\Binatone2005\iDECT_X1\iDECT_X1_UK_draft02a.vp
25 August 2005 16:47:49
"Last Number When you first make a call, after keying in the outside
line access code (e.g. 9), press and hold the
Redial and/or
Number Redial button until a
memory dialling
display. This inserts a pause between the access code
don't work on
and the telephone number. You should later be able to
a PBX."
redial the number.
When storing numbers in memory, you can include the
outside line access code (e.g. 9) with each number.
If your PBX requires you to wait for a second Dial tone
before dialling the telephone number, press and hold
the Last Number Redial button for a pause
between the access code and the number.
If the fault persists ...
Disconnect all other instruments connected to the
same line as the iDECT X1 and see whether you can
make a call.
Disconnect the base unit from the telephone line and
plug a different phone into the master telephone
socket. Try making a call. If this works, the line is OK.
If the call does not work, and you are using a two-way
socket adapter, remove it and plug a telephone
directly into the socket. If the call now works, the
adapter may be faulty.
If you cannot make a call, the fault may be on the
exchange line. Contact the service provider (the BT
engineers on 151, or your cable company).
If you still cannot identify the cause of the problem,
contact the Help Line on 0845 345 9677.
Help Line: 0845 345 9677
(Local Call rate)
Troubleshooting
Last
P appears on the
47