Table of Contents
Advertisement
OPERATION continued
Pressing the FAN PULSE key will activate the lower fan speed
and light its LED. The fan will be active for 30 seconds then off
for 30 seconds, and continues this cycle.
Pressing the SETBACK key will cool the oven cavity to a
preprogrammed temperature, see: Setting "Set-Back" Feature.
The oven will automatically go into Setback mode after the
pre-programmed non-usage time. The display will indicate
"SETB". This is an energy-saving feature.
Pressing the COOL DOWN key will deactivate the heat, turn
the fan on high and light its LED. The display will indicate
"OPEN DOOR" if the door is closed, prompting the user to
open the door slightly. With the door open slightly the display
will indicate "COOL". The Cool Down will operate when the
door is closed or opened slightly. Optimal cool-down will be
achieved with the door open slightly . When the door opens
wider, the Cool Down mode will deactivate and the display
will indicate "DOOR". This is a patented safety feature. Pressing
the COOL DOWN key again will turn the LED off and stop this
mode. Pressing the ON/OFF key will also cancel Cool Down.
Cool Down is not active during a cook.
When the ON/OFF switch is pressed to turn the oven off and
the oven was above 200°F (93°C), the oven will go into an
Auto Cool Down mode. In Auto Cool Down, the oven will
run the fan on high until the oven cavity drops below 150°F
(66°C). During this time the display will indicate "AUTO".
When the oven temperature drops below 150°F (66°C) the
oven turns off. This feature protects the oven motor from pre-
mature failure. Optimal cool-down will be achieved with the
door open slightly.
Fahrenheit/Celsius
Factory default is Fahrenheit (F). To change to
Celsius (C), press and hold in the "Phantom Key" located
to the right of "Cook/Hold" key. "F" appears in the display.
Continue to hold until "C" is displayed and then release the
"Phantom key".
Operating the Controls
Setting the cook temperature and time are done in the same
manner. Pressing the SET key will light the TEMP LED. The
operator then sets the temperature by rotating the dial on
the controller until the desired temperature is shown on the
display. Pressing the SET key a second time lights the TIME
LED and allows the operator to select the desired cook time as
shown on the display. Pressing the SET key a third time ends
the programming.
Part # 1955200 Rev.6 07/03/12)
Page 11
Hide quick links:
Advertisement
Table of Contents
