Changing The Light Bulb; Cleaning Exterior/Drip Tray - Westinghouse WSE7000 User Manual

CHANGiNG tHE LiGHt bULb

fREEzER LiGHt (wHERE fittEd)
1 Switch off the power at the power point and remove
the refrigerator's power cord from the power point.
2 Carefully unclip the light cover by pulling the light cover
tab at the rear, towards you Unclip the light cover by
pressing side tabs on both sides and pulling the light
cover away from you (Ice & Water models)
Models WSE7000 & WSE6100
Models WSE6970 & WSE6070
3 Unscrew the light bulb and replace it with a new bulb
of the same type and wattage If, when you remove the
light bulb the small rubber 'O' ring comes out with the
bulb, fit the 'O' ring over the new bulb and screw bulb
into the socket (see diagram at bottom of page)
Never insert your finger into the light bulb socket to
WARNING
check for the presence of the 'O' ring.
4. R eplace the light cover by hooking the light cover lugs
into the front of the housing and pressing the rear of the
cover up until it clips in
5 Wait 5 minutes to ensure pressures in the refrigeration
system are equalised before turning the refrigerator on
at the power point
WARNING
Ensure the 'O' ring is in place before replacing the bulb.
Light bulb 'O' ring
32 care & maintenance
CLEANiNG YoUR REfRiGERAtoR
CLEANiNG tHE ExtERioR
BEFORE CLEANING: Turn the refrigerator off at the
power point and unplug the cord to prevent any chance
of electrocution
Cabinet & painted doors – An occasional wipe over with
a clean, damp cloth will help remove finger marks You
should only clean the doors with lukewarm, soapy water
and a soft cloth. Rinse with clean water and then wipe
the surface with a soft, clean cloth to remove any
soapy residue
Note: only wash plastic parts or decorative trim with warm
(not hot) water using an unscented detergent.
Stainless Steel doors –Your stainless steel appliance is
manufactured from a mark resistant stainless steel This stainless
steel has a special advanced protective coating that helps
ease the removal of marks such as finger prints or water spots
To keep your stainless steel refrigerator looking its best, you
should clean it regularly You should only clean the stainless
steel doors with lukewarm soapy water and a soft cloth. Rinse
with clean water and then wipe the surface with clean water
and a soft, clean cloth to remove any soap residue
Do not use abrasive pads or other cleaners as they are
likely to scratch the surface Damage to this product after
installation is not covered by your warranty
Note: It is important to wipe in the direction of the grain of
the stainless steel to avoid any undue marking of the surface.
drip tray
Water may accumulate in the sump located under the drip
tray If this occurs the sump can be sponged out to prevent
water overflowing down the front of the door
For cleaning, remove the tray as described below:
1
2
3
Light socket
WARNING
CAUTION
Press down at the back of the drip tray with the tips
of your fingers
Pull the tray forward
To refit, slide the drip tray back into position and
push into place (see Diagram below)
1 Push down
2 Slide out