Westinghouse WSE7000 User Manual page 15

iCE & wAtER iNStALLAtioN
Step 15
Using a large container run the water dispenser to clear air
from lines This may take a few minutes Purge and dispense
a minimum of 2 litres of water or until the water runs clear
Initial water may be black in colour This is residual carbon
dust from the filter and is non-toxic If the water is slow to
shut off or the dispenser is dripping, air may still be in the
lines Either purge more water through the system to remove
this air or allow some time for the air to be removed over
subsequent dispensing
Step 16
Switch ON Ice Maker, touch and hold 'cubed/crushed
ice' button for 5 seconds.
freezer
temp
drinks
chill
Step 17
After 24 hours remove ice bin and dispose of first few
batches of ice to ensure that impurities have been flushed
from the system
fridge
temp.
display quick eco/
lock freeze holiday
Tips and Useful information
Ensure that taps are turned off when replacing
and fitting filters. Remember to turn the taps back
on when filter fitting is complete
Always fit filter as per manufacturer's instructions,
paying special attention to water flow direction
If you need to replace water tube, only use
approved water quality piping that meets the
pressure requirements
Do not allow the water tubing to become kinked
or trapped under the refrigerator when moving the
refrigerator back into position
Make sure your refrigerator is level to avoid uneven
or oversize cubes Uneven ice cubes may lead to
the dispenser chute becoming blocked
After installation, run the water dispenser for a few
minutes to ensure that all air bubbles have been
purged from the tubing Dripping may occur if air
bubbles remain in the tube
Replace filter at suggested intervals to avoid
water/ice reduction and irregularities in taste
Remove and clean ice bin once a month,
discarding unused ice cubes This will ensure fresh,
clean ice and smooth operation of your ice maker
Clean and empty the dispenser drip tray regularly
to avoid overflow
As the water/ice cut off is not instant, leave glass
under dispenser briefly until water or ice has
stopped flowing to avoid spills
Always place ice in glass before filling with water
to avoid splashing
When dispensing ice hold the container close to
the chute to avoid spray or spills
If you are using your refrigerator for the first time, or if you
have not used the dispenser for some time:
• Discard the first seven or eight cups of water
• D iscard any ice that the ice maker produces in the
first 24 hours (contaminants could have settled in the
water pipes)
installation 15