Westinghouse WSE7000 User Manual page 13

iNStALLiNG YoUR iCE & wAtER fiLtER
Check for water leaks at all water connection points in the
first 2 to 3 hours after installation, and correct it in case of
any water leak. Recheck after 24 hours; if leak still occurs,
it is recommended to contact a licensed plumber for advice
iNStALLAtioN
Water is to be connected as per diagram below
sink
mains brackets
water
inlet
½" tap
fitting
kitchen
cupboard
Step 1
Ensure that the Ice Maker is switched OFF
freezer
temp
Icemaker off
hold off drinks display
chill lock
Step 2
Disconnect refrigerator from power supply
Step 3
Connect tap fitting to water supply tap Tap must be close
to the refrigerator
fridge
temp.
quick eco/
freeze holiday
Step 4
Install brackets for filter within 1 metre of tap
WARNING
Do not screw the brackets into the refrigerator as this
may void your warranty and permanently damage
the refrigerator
Step 5
Write date on filter The filter will need to be replaced
every 12 months
Step 6
Extend the red collar and clip a circlip around the collar
at both ends of the filter
Step 7
Fit filter to brackets with water flow arrow pointing up
water
flow
direction
installation 13