Moving Your Cooker - Rangemaster Toledo 110 Ceramic User Manual

Hide thumbs Also See for Toledo 110 Ceramic:
Table of Contents

Advertisement

GB/IE
The oven control settings and cooking times given opposite are
intended to be used only as a guide. Individual tastes may require the
temperature to be altered to provide a preferred result.
When baking in the right hand fanned oven, use the minimum cooking time
shown in the table. Food is cooked at lower temperature in a fan oven than in a
conventional oven. When using recipes, reduce the temperature by 10°C and
the cooking time by 5-10 minutes. The temperature in the fanned oven does not
vary with height in the oven - so you can use any shelf.
Always leave at least one runner space between shelves when 2 tier cooking.
Place baking trays, individual cake tins or baking dishes centrally on the
oven shelf. For best results pre-heat the oven until the oven indicator
light goes out.

Moving your cooker

Switch off the electricity supply.
The cooker is heavy; two people may be
required to move it. The cooker is fitted
with one roller at the front and two at the
back. There are also two screw down
levelling feet at the front.
The front roller, designed for moving the cooker
can be wound down. The levelling tool that
controls this roller is in the storage drawer
compartment.
Remove the storage drawer (by pulling it
right out and lifting it up slightly) and you
should see the levelling tool.
Your installer may not have left the levelling tool
in place. If not, locate it as shown. If you cannot
find the levelling tool, contact your installer.
Turn the levelling tool clockwise, two full
(180°) turns. It will be stiff. The front of
the oven will rise slightly as the roller
drops down.
Open the grill door and right hand oven door so
that you can get a good grip on the bottom of the
fascia panel as you move the oven.
Do not move the oven by pulling the
handrail, door handles or knobs.
Move the oven a bit at a time, checking behind it
to make sure the power cable is not caught.
Make sure the electricity cable has sufficient
slack to move the cooker forward as you go
along.
When you replace the cooker, wind it down off
the rollers by turning the levelling tool anti-
clockwise. This is important. It will stop the
cooker moving accidentally, while in use.
14

Advertisement

Table of Contents
loading

Table of Contents