Attach The Bare Floor Tool; Machine Preparation; Bare Floor Cleaning Technique - Bissell 1692 PowerSteamer Clearview User Manual

Attach the Bare Floor Tool

Step on the handle release to lay the machine handle down.
1.
Remove the Tank-in Tank from the machine base.
2.
Lift the machine base to expose the underside of the nozzle.
3.
Attach Bare Floor Tool to nozzle with long tab to the right side
4.
(ReadyTools side) of the nozzle.
First attach left side (short Tab) catching tab over nozzle edge.
5.
Gently bend long tab (right side) outward to easily snap over
6.
edge of clear nozzle on left.

Machine Preparation

Set up machine following instructions in The Basics on pages
1.
6-9. Be sure to thoroughly rinse out any remaining Fiber
Cleansing Formula from the Tank-in-Tank bottle to prevent
slippery linoleum, vinyl, and tile floors. Use BISSELL Floor
Cleansing Formula in the Tank-in-Tank.
Check ReadyTools dial - it should be set on FLOOR CLEANING.
2.
Plug into a proper outlet and turn Power Switch ON.
3.

Bare Floor Cleaning Technique

Slowly move the machine nozzle with Bare Floor Tool
1.
forward and back over soiled surface one time while
pressing the trigger. Caution: Do not over wet.
Repeat the motion without pressing the trigger using the Bare
2.
Floor Tool to squeegee and suction up the dirty water.
Repeat steps 1 and 2 backing along the exit path.
3.
Allow about 30 minutes for the floor to dry completely.
4.
When the cleaning job is complete refer to the
5.
Maintenance/Storage section on page 13.
To remove Bare Floor Tool gently bend long tab (right side)
6.
outward and pull tool down away from nozzle. Rinse
thoroughly, dry and store.
Tilt
Handle
Back
Handle Release
Carrying
Bottom Front Edge of
Machine Base
Bare Floor
Snap Together
Cleaning Tool
WARNING:
To reduce the risk of fire,
electric shock or injury
unplug from outlet
before servicing.
11