Maintenance & Storage; Pump & Brush Belts Replacement; To Remove Broken Pump & Brush Belts - Bissell 1692 PowerSteamer Clearview User Manual

Maintenance/Storage
Turn Power Switch OFF.
1.
Unplug Power Cord from outlet and coil cord
2.
around Power Cord Quick Release.
Remove and rinse tools, if used, in clean, running
3.
water. Dry and replace.
Coil Flex Hose through storage brackets.
4.
Remove Tank-in-Tank. Dispose of dirty water. See
5.
The Basics section, page 8.
Rinse out Tank-in-Tank and reseat the tank unto
6.
the machine.
Wipe all exterior surfaces with a soft cloth.
7.
Store cleaner in a protected, dry area.
8.
When carpet is dry, vacuum again to remove
9.
hair and fuzz that the PowerSteamer may
have loosened.
Pump & Brush Belts Replacement
To Remove Broken Pump & Brush Belts
NOTE: Turn off machine and unplug from
wall outlet.
Step on Handle Release pedal and recline Handle
1.
on floor (see illustration).
Remove the Tank-in-Tank. Set aside (see illustration).
2.
Remove the Belt Access Door located near the
3.
ReadyTools Dial. Insert a flathead screwdriver into
the slot nearest the handle to gently pry off the
door (see illustration).
Power Cord
Quick Release
Flex Hose
Storage Bracket
CAUTION:
PowerSteamer ® uses water
and must not be stored
where there is a danger of
freezing. Freezing will
damage internal components
and void the warranty.
1
2
3
13