Table of Contents
Advertisement
the V-belt is correctly tensioned when there
is approximately
pushed with moderate pressure, as shown in
figure 42.
Deflection
figure 42. Correct V-belt deflection.
—if there is more than
V-belt is pushed with moderate pressure,
loosen the four cap screws, and adjust the
tension until it is correct.
5.
Close and secure the end cover.
Replacing v-belt
1.
disCoNNECt lathE FroM poWEr!
2.
open the end cover.
3.
loosen the four cap screws shown in figure
41 on page 36.
4.
Carefully roll the V-belt off of the pulleys.
5.
install a new V-belt, then tension it as
described on page 36.
Model G0745 (Mfg. Since 11/13)
⁄
" deflection when it is
1
8
Pulley
⁄
"
1
8
Pulley
⁄
" deflection when the
1
8
fuse Replacement
Tool Needed
Flat head screwdriver #1 .................................. 1
replacement part number: p0745125.
if the spindle does not start, replace the fuse.
To replace the fuse:
1.
using the screwdriver, push and twist the
fuse holder (see figure 43) to remove it from
the hole in the rear of the headstock.
Fuse holder
hole
figure 43. Fuse holder and fuse.
2.
insert a new fuse into the fuse holder.
3.
re-install the fuse holder.
Qty
Fuse
Fuse holder
-37-
Advertisement
Table of Contents
