KL1508Ai / KL1516Ai User Manual
Adding Filters
To add an IP filter, do the following:
1. Click Add. A script prompt dialog box appears.
2. Specify whether you are filtering an IPv4 or IPv6 address.
3. Key the address you want to filter in the Start: field
4. Click OK.
5. Key the address you want to filter in the End: field.
Note: This description is for the AP GUI. The Browser GUI differs as
follows:
1. It doesn't offer an IPv4 or IPv6 choice. It only has From and
To fields for IPv4 filtering.
2. It doesn't have a checkbox to specify a single IP address. To
filter a single IPv4 address, key the same address in both the
From and To fields.
6. Click OK.
7. Repeat these steps for any additional IP addresses, or IP Address ranges
you want to filter.
138