ATEN KL1508Ai User Manual page 147

To allow authentication and authorization for the KL1508Ai / KL1516Ai
via LDAP / LDAPS, refer to the information in the table, below:
Item
Enable
Type
LDAP Server IP
and Port
Timeout
Admin DN
Password
Admin Name
Search DN
Admin Group
Put a check in the Enable checkbox to allow LDAP / LDAPS
authentication and authorization.
Click a radio button to specify whether to use LDAP or LDAPS.
Fill in the IP address and port number for the LDAP or LDAPS
server.
You can use the IPv4 address, the IPv6 address or the
domain name in the LDAP Server field.
For LDAP, the default port number is 389; for LDAPS, the
default port number is 636.
Set the time in seconds that the
waits for an LDAP or LDAPS server reply before it times out.
Consult the LDAP / LDAPS administrator to ascertain the
appropriate entry for this field. For example, the entry might
look like this:
ou=kl1516ai,dc=aten,dc=com
Key in the LDAP administrator's password.
Key in the LDAP administrator's username.
Set the distinguished name of the search base. This is the
domain name where the search starts for user names.
Key in the Group Name for KL1508Ai / KL1516Ai administrator
users.
If Enable Authorization is not checked, this field is used to
authorize users that are logging in. If a user is in this group, the
user receives full access rights. If a user is not in this group, the
user only receives limited access rights. Consult the LDAP /
LDAPS administrator to ascertain the appropriate value.
Chapter 11. Device Management
Action
KL1508Ai / KL1516Ai
(Continues on next page.)
133