Icom IC-R6 Instruction Manual page 53

D VFO scan watch
q Select the channel(s) to be watched.
For a memory channel watch:
Select a desired memory channel.
For a memory scan watch:
➥ Push [V/M] to select the memory mode.
➥ Hold down [SCAN](MODE) for 1 second to enter the
scan type selection mode.
➥ Rotate [DIAL] to select a desired scan type, then push
[SCAN](MODE) again to start the memory/bank scan.
w Hold down [SET](TS) for 1 second to enter the Set mode.
e Rotate [DIAL] to select the priority watch set item.
r While holding down [FUNC], rotate [DIAL] to select "ON."
• Select "BELL" if the priority beep function is desired.
After 1 sec.
t Push [SET](TS) to exit the Set mode and start the watch.
• The "PRIO" icon appears.
y Hold down [SCAN](MODE) for 1 second to enter the scan
type selection mode.
u Rotate [DIAL] to select a desired scan type from "ALL,"
"BAND," "P-LINK x
(x= 0 to 9)
" or "PROGxx ."
(xx= 0–24)
i Push [SCAN](MODE) to start the VFO scan watch.
• The receiver checks the memory channel(s) every 5 seconds.
• The watch resumes according to the selected scan resume set-
ting. (p. 37)
During a VFO scan watch
Searches the VFO frequen-
cies for 5 seconds.
During a VFO scan watch with the priority beep
A beep tone sounds and the "S" icon blinks when a
signal is received on a memory channel.
o Push [SET](TS) to cancel the watch and scan.
7
PRIORITY WATCH
Pauses on a memory
channel when a signal is
received.
7
40