Atteries - Icom IC-R6 Instruction Manual

u POWER KEY [ ]
Hold down for 1 second to turn the receiver power ON or
OFF.
i MODE • SCAN • TONE SCAN KEY
[MODE] • [SCAN](MODE) • [
➥ Push to select the receive mode. (p. 14)
➥ Hold down for 1 second to enter the scan type selec-
tion mode. (pp. 29, 33)
• Push again to start the scan.
➥ While holding down [FUNC], push to start a tone scan.
(p. 44)
o VFO/MEMORY • MEMORY WRITE • SKIP KEY
[V/M] • [S.MW](V/M) • [
➥ Toggles between the VFO and the memory mode. (p. 9)
➥ Hold down for 1 second to enter the memory edit
mode. (p. 19)
While in the VFO mode
m
Hold down [FUNC], then push this key to set the VFO
skip scan setting ON or OFF.
While in the memory mode
m
Hold down [FUNC], then push this key to select the
scan skip setting for the selected channel.
* The functions of [DIAL] and [p]/[q] can be exchanged.
See page 58 for details.
](MODE)
](V/M)
(p. 29)
(p. 35)
PANEL DESCRIPTION
!0 EXTERNAL DC-IN CONNECTOR [DC4.5V] (p. 7)
Connect an AC adapter or an optional cigarette lighter
cable for both charging the installed rechargeable battery
and operating. Connectable voltage is from 4.5 V DC to
6.3 V DC.
!1 EXTERNAL SPEAKER CONNECTOR [SP]
Connect an optional earphone or headphones.
The internal speaker will not function when any external
equipment is connected. (See page 79 for a list of avail-
able options.)
!2 CONTROL DIAL [DIAL]*
➥ Rotate to select the operating frequency. (p. 11)
➥ While scanning, changes the scanning direction.
(pp. 29, 33)
➥ While holding down [SQL], sets the squelch level.
(p. 14)
➥ While holding down [FUNC], sets the operating fre-
quency in 100 kHz, 1 MHz or 10 MHz in the VFO
mode. (pp. 11, 17)
➥ While holding down [FUNC], selects the memory
channel in 10 channels steps in the memory mode.
(pp. 12, 18)
➥ While holding down [BAND], selects the frequency
band in the VFO mode. (p. 9)
1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
2