Icom IC-M801E Instruction Manual page 30

7
CALL PROCEDURE
D Individual call operation— continued
i When receiving an acknowledgement, the display
shows the received ID code, or the called station
name.
• Push [FREQ/CH];
- to select the traffic frequency if the called station is
able to comply to the call.
- to return to DSC watch mode when unable.
When the called station is unable to comply
to the call, the reason may be displayed.
o Announce the following message to the connected
station.
- The 9-digit identity (or call sign or other identifi-
cation) of the station which you want to call.
- "This is ..... (your ship name)."
- The 9-digit identity OR call sign (or other identifi-
cation of the ship).
When no acknowledgement is received:
z Wait for 5 min., then call again on the same or
a different frequency.
x If no acknowledgement is received after a 2nd
call, wait for at least 15 min. before repeating
the call.
✔ INFORMATION
The IC-M801E will not transmit the DSC call
even [CALL] when the set calling fre-
emergency call)
quency is in busy. The transceiver waits the DSC
call transmission until the calling frequency be-
comes clear in this case.
22
✔ CONVENIENT!
The IC-M801E has DSC TX memory. You can store
often used DSC calling conditions for quick and sim-
ple re-call. Up to 10 conditions can be stored into the
memory with the following instructions.
¡ When call stand-by screen is displayed as in step
y in page 21, push and hold [ENT] for 1 sec.
™ Rotate [CH] to select the desired TX memory chan-
nel number.
Ç
£ Push and hold [ENT] for 1 sec. again to store the
condition into the selected memory channel.
Ç
¢ Push [ENT] to return to the calling stand-by condi-
tion.
∞ Push and hold [CALL] for 1 sec. when transmitting
the DSC call in set condition, or push [MODE
when returning to DSC watch mode.
(except
]
SET