Speaker-Microphone; I Description; I Attachment - Icom IC-M1EURO V Instruction Manual

10

SPEAKER-MICROPHONE

I Descriptions
Alligator type clip
To attach the speaker-mic.
to your shirt or collar, etc.
PTT switch
Transmits during push
Receives during release
Microphone
Speaker
NEVER immerse the connector in water. If the connector be-
comes wet, be sure to dry BEFORE attaching it to the trans-
ceiver.
NOTE: The microphone is located at the top of the
speaker-microphone, as shown in the diagram above. To
maximize the readability of your transmitted signal
hold the microphone approx. 2.5 cm from your mouth, and
speak in a normal voice level.
22

I Attachment

Insert the connector of the speaker-microphone into the
[SP MIC] connector on the transceiver and rotate
connector cover as shown in the diagram below.
IMPORTANT: KEEP the [SP MIC] jack cover attached
the transceiver)
Water will not get into the transceiver even if the cover is
, not attached, however, the terminals
(voice)
rusty, or the transceiver will function abnormally if the con-
nector has become wet.
CAUTION: Attach the speaker-
microphone's connector secure-
ly to prevent accidental drop-
ping, or water intrusion in the
connector.
when the speaker-microphone is not in use.
(pins)
the
(screw)
(on
will become