Conventional Operation; Turning Power On; Channel Selection - Icom IC-F50 Instruction Manual

CONVENTIONAL OPERATION

I Turning power ON
q Rotate [VOL] to turn power ON.
w If the transceiver is programmed for a start up passcode, input
digit codes as directed by your dealer.
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identical.
Therefore "01234" and "56789" are the same.
KEY
NUMBER
e When the "PASSWORD" indication does not clear after inputting
4 digits, the input code number may be incorrect. Turn the power
off and start over in this case.
I Channel selection
Several types of channel selections are available. Methods may dif-
fer according to your system set up.
NON-BANK TYPE:
Push [ ]/[
quence; or, push one of the [MR-CH 1] to [MR-CH 4] keys to select
a channel directly.
BANK-TYPE:
Push [Bank], then push [
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning the
power ON, the transceiver automatically starts scanning. Scanning
stops when receiving a call.
0 1
5 6
] to select the desired operating channel, in se-
] or [
2 3
7 8
] to select the desired bank.
3
2
3
4
9
12