Furuno CH-250 Operator's Manual page 86

5.2.3 Short-cut key
The default settings are key [1], interference rejector; key [2], signal level, and key [3],
background color. The operator may change their functions as desired.
Note: In the combination modes the short-cut key operation is only possible from the main
window.
1. Select SHORT-CUT following the procedure in paragraph 5.2.1 on page 5-3.
2. Press the [MENU] key to open the menu.
3. Press to select MENU, and then press
MENU
KEY 1
KEY 2
KEY 3
SELECT FUNCTION TO BE ALLOCATED TO EACH CUSTOM KEY.
CUSTOM KEY MAY BE USED AS A PRESET KEY.
: SELECT
4. Press or to select key to preset. For example select KEY 1.
5. Press or to select item.
6. Press the [MENU] key to finish.
Activating a short-cut key
1. Press a CUSTOM MODE key, and the dialog box programmed for the custom key pressed
appears. The dialog box below is for the interference rejector.
INT REJ:
2. Press or to select option desired
3. Press the [MENU] key to close the dialog box.
5-6
COMN HORZ VERT ES
IR SIG LEVEL
COLOR RES.COLOR
IR SIG LEVEL
COLOR RES.COLOR
IR SIG LEVEL
COLOR RES.COLOR
: CHANGE
Figure 5-6 SHORT-CUT menu
OFF ON
or to select SHORT-CUT.
SHORT-CUT
BKGD WHITE MARKER
TRACK
BKGD WHITE MARKER
TRACK
BKGD WHITE MARKER
TRACK
MENU: END
SYS