Range And Bearing Markers - Furuno CH-250 Operator's Manual

2.9.2 Deleting all event markers
All event markers can be erased from the screen as follows:
1. Operate the Omnipad to place the cursor outside the display area.
2. Press the [EVENT] key to show the following dialog box. Do the next step within four
seconds, otherwise the dialog box will be erased.
DELETE EVENT MARK?
NO
3. Press to select YES and press the [MENU] key. All event markers are erased from the
screen.

2.10 Range and Bearing Markers

The horizontal range, depth and bearing to a fish school can be measured by using the range
and bearing markers.
1. Operate the Omnipad to place the cursor on the location desired.
2. Press the [R/B] key to display the range and bearing markers. Horizontal range, depth and
bearing to the cursor location are shown at the bottom right-hand corner of the screen.
3. To erase the range and bearing markers, place the cursor outside the display area and press
the [R/B] key, or place the cursor on the range or bearing marker and press the [R/B] key.
Bearing marker
YES
Range marker
Figure 2-12 Range and bearing markers
NAV
DATA
Range and bearing
markers data
:Horizontal range
: Depth
B: Bearing from ship's bow
2-11