Fujitsu Siemens Computers LIFEBOOK B Series Operating Manual page 69

Failure Fixed Disk n
The settings of the hard disk drive are incorrect.
Ê
Start the BIOS Setup (IDE Adapter 0 Master submenu) and select the correct settings.
Fixed Disk address conflict Diskette Drive address conflict
There is an I/O address conflict.
Ê
Start the BIOS Setup and check the corresponding settings.
Incorrect Drive A type - run SETUP
Ê
Start the BIOS Setup and make sure that the parameter for floppy disk drive A has been set to
the format 1.44 MB, 3 ½ inch.
Keyboard controller error
Ê
Switch the notebook off with the ON/OFF switch.
Ê
Wait 3 - 5 seconds and switch on the notebook again.
Should you receive this error message again, please contact your dealer.
Keyboard error
If you use an external keyboard:
Ê
Check the connection and reboot the notebook.
Should you receive this error message again, please contact your dealer.
nn Stuck key
Ê
Make sure that no key is pressed.
Should you receive this error message again, please contact your dealer.
Operating system not found
Ê
Check in the BIOS Setup whether your hard disk has been set correctly.
Ê
Make sure that the operating system is installed on the corresponding drive.
Not enough Save-to-Disk partition or file exists on Fixed Disk - Save-to-Disk feature is
disabled.
The Save to Disk mode is not available to you, as no memory space has been assigned to this mode.
Ê
Use the PHDISK service programme to assign the memory space required for this mode.
Press <F1> to resume, <F2> to SETUP.
This error message appears if an error occurs during the self-test before starting the operating
system.
Ê
Press the [F1] [F1] function key to start the operating system.
[F1] [F1]
Ê Enter the BIOS Setup programme by pressing [F2]
Previous boot incomplete - Default configuration used
Due to an error during the previous system boot, default values were used for certain settings.
Check the BIOS Setup and the settings.
Ê
Press the [F1] [F1] function key when prompted to do so.
[F1] [F1]
A26391-K105-Z120-1-7619
Troubleshooting and tips
[F2].
[F2] [F2]
61