Erasing Automix Data On Specified Channels; Erasing Automix Data - Roland VS-1680 User Manual

Chapter 9 Automix
Shift
Specify the actual amount (-50–50) by which the Automix
data values will be increased or decreased.
fig.4-25.e
Shift
0 M1 M8
Time
Expand
Specify the ratio (0.5–2.0) by which the Automix data values
will be increased or decreased relative to the "Threshold."
Threshold
When using Expand to increase or decrease the Automix
data values by a specified proportion, this specifies the center
value.
fig.4-26.e
Expand
0 M1 M8
Time
11. To execute the Shift/Expand operation, press [F4 (Exec)].
If you press [F6 (EXIT)], you will return to Step 7 without
executing the Shift/Expand operation.
12. A message will ask you to confirm. Press [YES]. If you
press [NO], you will return to Step 11 without executing
the Shift/Expand operation.
fig.4-27_80
13. When the Shift/Expand operation has been completed,
the display will indicate "Complete." Press
[PLAY (DISPLAY)].
136
Threshold
Erasing Automix Data on
Specified Channels
1. Locate to the point where you want to erase the Automix
data.
2. Confirm that Automix is on.
3. Select the channels for which you want Automix erased.
Hold [AUTOMIX] and press the desired Input SELECT,
Track SELECT, or SOLO/EDIT buttons so they are
flashing.
4. Hold [SCENE] and press [CLEAR]. Automix is erased on
the selected channels.

Erasing Automix Data

You may end up recording Automix data only to
immediately decide you want to try it again. Do not try to
use the UNDO button to erase Automix. Erase Automix data
using one of the following two methods.
To Quickly Erase all Automix Data, Including
Snapshots
This procedure will erase ALL markers in the VS-1680!
1. Hold [SHIFT] and [CLEAR], and press [TAP]. "Clear All
Tap Markers?" appears in the display.
2. Press [YES]. Or, if you wish to cancel the operation, press
[NO].
To Erase Selected Automix Data
1. Hold [SHIFT] and press [F6 (UTIL)]. The Utility menu
icon appears.
2. Press [F5 (A.Mix)]. If "A.Mix" does not appear above
[F5], press [PAGE] and then press [F5 (A.Mix)].
3. Press [F4 (Erase)]. The Automix Erase screen appears in
the display.
4. Press [
], [ ], [
cursor, and use the TIME/VALUE dial to change
settings.
fig.11-14
], and [ ] to move the