Track which you want written as the right track
Track which you want written as the left track
Song Name
Internal IDE hard disk free space
Disk space occupied by a song when written to a CD-R disc
Size of the content written to the CD-R disc
Length of the song which is to be written to the CD-R disc
Number of tracks after writing to the disc is finished
Number of Markers used for track numbers
Determining whether or not the CD-R disc has data written to it
Source Track Length (in Mbyte) compared
to Free disc space on CD-R/CD-RW
The amount of drive space source tracks occupy on the
VS-1680 may not be the same amount of disc space it
occupies on a CD-R/CD-RW disc. The track size on the
VS-1680 varies depending on the number of tracks and
recording mode used. You can make a rough estimate of
the space required on a CD-R/CD-RW disc for a tracks
to be written by using the following calculation:
Source track length (in seconds) x 2 (bytes) x 2 (stereo
tracks) x 44,100 = SIZE (bytes)
For example, a source track which is 60 minutes long
(3,600 seconds) occupies:
3,600 x 2 x 2 x 44,1000 = 635,040,000 bytes = 635 MB
CD-R disc free space
Chapter 13 CD-RW and Mastering
12. Press
], [
], [
cursor to Finalize and Write Method and use the TIME/
VALUE dial to select the desired settings. To learn about
Finalize and Write Method, see "Finalizing," p. 176.
13. Press [F4 (Exec)].
14. "Audio CD-R Write Sure ?" and "CD Track No. OK?"
appears in the display. This message confirms the
Finalize setting, and makes sure CD track markers are
set. Press [YES], or to cancel the operation, press [NO].
15. A message regarding copyright appears in the display.
After reading this message carefully, if you agree to the
conditions, press [YES]. To cancel, press [NO].
16. A message regarding licensing conditions appears in the
display. After reading this message carefully, if you
agree to the conditions, press [YES]. To cancel the
operation, press [NO].
17. After the CD-R writing is finished, "Write Another ?"
appears in the display. If you want to write the same
track data to another CD-R disc, place a new disc in the
CD-R/CD-RW drive and press [YES]. Press [NO] to
return to Step 2.
], and [
] to move the
183