Roland VS-1680 User Manual page 179

10. Select the left and right tracks from the VS-1680 that you
want written to the CD-R. Use [
and [ ] and the TIME/VALUE dial to move the
cursor to the V-Track you want written as the left
channel of the CD-R, and press [F3 (Sel L)]. Move the
cursor to the V-Track you want written as the right
channel of the CD-R and press [F4 (Sel R)].
You can use [ ], and [
and then use the TIME/VALUE dial to select the desired
V-Track.
11. Press [F1 (Back)].
12. Verify that the Length megabyte value is less than the
value for IDE Free in the lower-left corner of the display.
13. Verify that the Length megabyte value is also less than
the value for Free—the amount of free space on the CD—
in the lower right-hand corner.
], [ ], [ ],
] to jump from track to track,
Chapter 13 Mastering
Track which you want written as the right track
Track which you want written as the left track
Song Name
Internal IDE hard disk free space
Disk space occupied by a song when written to a CD-R disc
Size of the content written to the CD-R disc
Length of the song which is to be written to the CD-R disc
Number of tracks after writing to the disc is finished
Number of Markers used for track numbers
Determining whether or not the CD-R disc has data written to it
Source Track Length (in Mbyte) compared
to Free Disc Space on CD-R
The amount of drive space source tracks occupy on the
VS-1680 may not be the same amount of disc space it
occupies on a CD-R disc. The track size on the VS-1680
varies depending on the number of tracks and recording
mode used. You can make a rough estimate of the space
required on a CD-R disc for a tracks to be written by
using the following calculation:
Source track length (in seconds) x 2 (bytes) x 2 (stereo
tracks) x 44,100 = SIZE (bytes)
For example, a source track that is 60 minutes long (3,600
seconds) occupies:
3,600 x 2 x 2 x 44,1000 = 635,040,000 bytes = 635 MB
CD-R disc free space
179