Roland VS-1680 User Manual page 131

fig.4-03
6. Make sure that the cursor is located at "Edit Target," and
use the TIME/VALUE dial to select the Automix data
that you wish to erase.
7. Use [
] and [ ] to move to the first marker of the
area from which you wish to erase Automix data, and
press [F1 (In)].
8. Use [
] and [ ] to move to the last marker of the
area from which you wish to erase Automix value, and
press [F1 (Out)]. Checkmarks will be added to the area
specified for erasure.
fig.4-04.e
Check marks
Even if you wish to erase the Automix data for only one
marker, press [F1 (In)] and then [F1 (Out)] for the desired
marker.
You can turn the TIME/VALUE dial to modify the Automix
setting value at the cursor location. If you wish to re-select
the Automix value that will be erased, press [
9. Press [F2 (Erase)].
fig.4-05_80
Target
This will indicate the type of Automix data that you selected
to be erased in Step 6. If you wish to erase all Automix data,
use the TIME/VALUE dial to select "All Level and Pan."
10. If you wish to erase the data, press [F4 (Exec)]. If you
press [F6 (EXIT)], you will return to Step 7 without
erasing any data.
11. A message will ask you to confirm the operation. Press
[YES]. If you press [NO], the erasure will be halted, and
you will return to Step 10.
fig.4-06
12. When the data has been erased, the display will indicate
"Complete." Press [PLAY (DISPLAY)].
Copying Data to Another Location
This operation copies Automix data from a specific area, and
overwrites it onto another location (specified data/time).
fig.4-07.e
Copy area
0 M0 M2 M4
M1 M3
Editing of the Automix data cannot be cancelled by the Undo
].
function.
1. Press [PLAY (DISPLAY)].
2. Hold down [SHIFT] and press [F6 (UTIL)].
Chapter 9 Automix
Destination
Marker
Time 0 M0 M2
M5 M1 M3
M4 Time
M5
131