Table Of Contents - Gemini GEM-P800 Using Manual

Table of Contents

Keypad Controls and Indicators ...................................
Arming your System (When Leaving) ........................... 5
Protecting Yourself While Home .................................. 6
Emergency Keys .......................................................... 7
Disarming the System .................................................. 8
Silencing an Alarm..................................................... ..
Resetting a Fire Alarm..................................................
Fire Protection .............................................................. 9
Special Functions ........................................................ 11
System Troubles .......................................................... 12
Programming User Codes ............................................ 14
Glossary ....................................................................... 15
Important - Test Your System Weekly !
1
Bell / Battery Test
Test your bell or siren by pressing
This will cause the bell, or siren to sound for 2 seconds
and also initiate a test of the battery .
2
Zone Test
Walk throughout the premises, opening each protected
door or window, and activating each motion sensor.
Check the keypad to see that each respective zone
number displays in the window.
Oi219c
page 3
4
Central Station Phone Number: ____________________
Central Station Account Number: ____________________
For Service Call: ____________________
8
8
Entry Delay: ____________________
Exit Delay: ____________________
Alarm Time-out: ____________________

3
Central Station Communication Test
(This test should only be performed on weekends or at a
time designated by your alarm company)
1 .Notify Central Station of the impending test.
followed by .
2. Secure all zones to light Status Light on your keypad.
3. Enter your User Code followed by
4. Violate your alarm by opening a window / door etc.
5. The siren or bell should sound and the system will send
the alarm signals to the Central Station
6 .Enter your User Code followed by
7. Call Central Station to insure that the alarm signals were
received properly.
Introduction
System Information

to Arm the system.

to silence the alarm.
Tuesday, September 16, 1997 08:24
3