Interrupting A Programme; Select The Desired Options; Cancelling A Programme; Programme Has Started - Zanussi ZWH 520 User Manual

7. Select the desired options

The light corresponding to the depressed button
illuminates.

8. Select the DELAY START option

To delay starting of the programme, press the
DELAY start button. The figures corresponding to the
selected delay will be displayed for about 3 seconds,
after which the duration of the selected programme
will appear on the display.
During this period it is possible to load other laundry:
• depress START/PAUSE button;
• open the door:
• load the laundry;
• colse the door and depress START/PAUSE button
again.

9. Start the programme

Press the START/PAUSE button. The relevant light
will stop flashing, and only the light relevant to the
phase that is in progress will remain lit.
If you have chosen a delayed start, the washing
machine will begin the countdown.
The display will show the duration of the programme
or the selected delay.

10. Altering a programme

You can alter the programme before it starts.
When the programme has started, you can only
reset it by turning the programme selector dial to O
and then you can select the new programme. Start it
by depressing the START/PAUSE button.

11. Interrupting a programme

Depress the START/PAUSE button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the same button again to
restart the programme.

12. Cancelling a programme

Turn the selector dial to O to cancel a programme
which is running. Now you can select a new
programme.
13. Opening the door after the

programme has started

First set the machine to PAUSE by pressing the
START/PAUSE button.
If the door does not open, this means that the
machine is already heating, that the water level is
above the bottom edge of the door or that the drum
is turning.
If you cannot open the door but you need to open it
you have to switch the machine off turning the
selector dial to O. After about 3 minutes the door can
be opened (pay attention to the water level and
temperature!). To restart the programme turn the dial
to the previous programme repeating the options
previously selected and press START/PAUSE
button.

14. At the end of the programme

The machine stops automatically.
If the NIGHT CYCLE option has been selected the
porthole remains blocked, the light of the
START/PAUSE button goes off, the RINSE HOLD
pilot light and the NIGHT CYLCE light remain lit, to
indicate that the water must be emptied out before
opening the door. The display shows a blinking zero
and some acoustic signals will be heard for about
two minutes. It is possible to eliminate the acoustic
signals by means of the SUPER RINSE button and
the START/PAUSE button together.
Turn the programme selector dial to Reset O to
switch the machine off .
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
18