Table of Contents
Advertisement
2. To change the temperature and/or the spin
speed, touch the related buttons.
3. If desired, set one or more options by touching
the related buttons. The related indicators
illuminate on the display and the given
information changes accordingly.
If a selection is not possible an
acoustic signal sounds.
STARTING A PROGRAMME
Touch the Start/Pause
programme. It is not possible to start the
programme when the indicator of the button is off
and doesn't flash (e.g. programme dial on a wrong
position).
The related indicator stops flashing and stays on.
The programme starts, the door is locked. The
display shows the indicator
The drain pump can operate shortly
before the appliance fills water.
STARTING A PROGRAMME WITH THE
DELAY START
1. Touch the Delay Start
the display shows the desired delay time. On the
display the indicator shows
2. Touch the Start/Pause
door locks and starts the countdown of the delay
start. The display shows the indicator
When the countdown is completed, the programme
starts automatically.
Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Delay Start
until the display shows the desired delay time.
On the display the indicator shows
Touch the Start/Pause
lock the door and starts the countdown of the delay
start. The display shows the indicator
When the countdown is completed, the programme
starts automatically.
2. Touch the Start/Pause
appliance. The related indicator flashes.
3. Touch the Delay Start
until the display shows
goes off.
button to start the
.
button repeatedly until
button. The appliance
.
button repeatedly
button. The appliance
.
button to pause the
button repeatedly
and the indicator
4. Touch the Start/Pause
the programme immediately.
Changing the delay start after the countdown
has started
To change the delay start:
1. Touch the Start/Pause
appliance. The related indicator flashes.
2. Touch the Delay Start
until the display shows the desired delay time.
3. Touch the Start/Pause
the new countdown.
THE SENSICARE SYSTEM LOAD DETECTION
After touching the Start/Pause
1. The SensiCare System starts estimating the
weight of the load to calculate the real
programme duration. During this phase the
FlexiTime bars
digits play a simple animation.
2. After about 15-20 minutes the FlexiTime bars
disappear and new cycle duration is displayed.
The appliance automatically adjusts the
programme duration to the load to achieve
perfect washing results in the minimum
possible time.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
When the programme is running, you can change
only some options:
1. Touch the Start/Pause
The related indicator flashes.
2. Change the options. The given information in
the display changes accordingly.
3. Touch the button Start/Pause
The washing programme continues.
CANCELLING A RUNNING PROGRAMME
1. Press the button ON/OFF to cancel the
programme and to deactivate the appliance.
2. Press the button ON/OFF again to activate the
appliance.
If the AutoAdjust System has
completed and the water filling has
already started, the new programme
starts without repeating the
AutoAdjust System. The water and
the detergent are not drained out in
order to avoid waste.
button again to start
button to pause the
button repeatedly
button again to start
button:
placed below the time
button.
again.
19
Advertisement
Table of Contents
