Table of Contents
Advertisement
Make sure that the detergent divider is inserted
properly and does not cause a blockage when you
close the drawer.
SETTING A PROGRAMME
1. Turn the programme knob and set the
programme:
•
The indicator
•
The display shows the level of the Time
Manager, the programme duration and the
indicators of the phases of the programme.
2. If necessary, change the temperature and the
spin speed or add available options. When you
activate an option, the indicator of the set
option comes on.
If you set something incorrect, the
display shows the message
STARTING A PROGRAMME WITHOUT THE
DELAY START
Press
.
•
The indicator of
stays on.
•
The indicator
display.
•
The programme starts, the door locks, the
display shows the indicator
•
The drain pump can operate for a short time
when the appliance fills water.
After approximately 15 minutes from
the start of the programme:
•
The appliance adjusts automatically
the programme duration agree with
the laundry load.
•
The display shows the new value.
38
flashes.
.
stops to flash and
starts to flash on the
.
STARTING A PROGRAMME WITH THE
DELAY START
1. Press
again and again until the display
shows the delay you want to set.
The related indicator comes on the display.
2. Press
:
•
The appliance starts the countdown.
•
The door locks, the display shows the
indicator
.
•
When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the delay start before you press the
. To cancel the delay start:
•
Press
to pause.
•
Press
shows
•
Press
programme immediately.
THE AUTOADJUST SYSTEM LOAD
DETECTION
After touching the Start/Pause
1. The AutoAdjust System starts estimating the
weight of the load to calculate the real
programme duration. During this phase the
display shows the simple animation.
2. After about 10-15 minutes new cycle duration
is displayed.
The appliance automatically adjusts the
programme duration to the load to achieve
perfect washing results in the minimum
possible time.
The AutoAdjust System is not available
with all programmes such as :Wool,
Rinse, SpinDrain, and programmes
with short cycles.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Press
.
The indicator flashes.
2. Change the options.
3. Press
again.
The programme continues.
to set the appliance
until the display
'.
again to start the
button:
Advertisement
Table of Contents
