Preparing The Rails For Integrated Shipping - HP R5000 User Manual

Install the rear mounting brackets using hex nuts. Wait until the unit is installed and the brackets are
7.
adjusted before tightening the nuts.

Preparing the rails for integrated shipping

If the unit is to be shipped in an HP 9000 or 10000 series rack:
Remove the hex nuts, flat washers, and lock washers from the mounting rail.
1.
Install the rail reinforcement plates and tighten using the hex nuts with captive washers included in the
2.
kit, instead of the nuts included with the rail.
Install the rear mounting brackets using hex nuts. Wait until the unit is installed and the brackets are
3.
adjusted before tightening the nuts.
Installation and configuration 16