Important Safeguards
Always follow these important safeguards:
1
2
3
4
5
6
7
Agency Certifications
Your unit complies with FCC rules, DOC requirements, and other agency certification
requirements. Refer to the Specifications chapter of this Operator Guide for further details.
1
Read all of these instructions before using the unit.
Plug the power cord into a 3-conductor
(grounded) outlet. Check the Specifications
chapter to make sure the outlet meets the ampere
rating of this unit.
•
Never ground the power cord to a gas pipe or
a water pipe.
•
Keep the power cord away from hot surfaces.
•
Avoid using an extension cord if possible.
•
If you must use an extension cord, use only a
3-conductor cord rated for the ampere rating
of your unit. Refer to the Specifications
Chapter for this value. Power cords rated for less can overheat and become a fire hazard.
Do not operate the unit if any part of it is damaged, or if any part has been dropped, until it
is checked by a authorized Lanier Service Technician.
The fusing area is hot. Exercise care in this area.
Do not install the unit in areas that are:
•
Damp or humid
•
Exposed to direct sunlight
•
Extremely dusty
•
Poorly ventilated
•
Close to machines generating ammonia such as diazo copy machines.
•
Subject to extreme temperature or humidity changes, for example, near an air
conditioner or heater
Place the unit on a firm, level surface.
For proper ventilation and cooling, keep the unit at least 6 inches on the right and back sides
of the copier.