Jacuzzi PALIO Owner's Manual page 19

TROUBLESHOOTING GUIDE
PROBLEM
5. Motor stops or
will not operate.
6. Air blower does not
operate.
7. Noisy motor/pump.
8. Water leakage at pump
shaft
(rotating connection
between
pump and motor.)
*Note: The skills and tools necessary for the safe repair of this spa require the services of quali
fied service personnel. Contact your Jacuzzi Whirlpool Bath dealer.
PROBABLE CAUSE
A. Thermostat satisfied in
HTR/FLTR mode.
B. Motor overload condition.
C. Inadequate electrical supply
to spa.
D. Spa circuit protector tripped.
E. System malfunction.
A. ACCESSORY switch not in
AIR mode.
B. Blower plug loose.
C. Blower disconnected from
plumbing.
D. System malfunction
E. Spa circuit protector tripped.
A. Clogged strainer or skimmer
basket.
B. Low water level.
C. Loose parts attached to
motor support brackets.
D. Leakage of air into suction
line.
E. Damaged or worn motor
bearings.
F. Impeller rubbing inside case.
G. Debris inside pump.
I. Plumbing shut-off valve not
fully open.
A. Worn of damaged pump seal.
REMEDY
A. Select FLTR or JETS mode.
B. Turn off motor and let cool for1
hr. If problem persists, see*Note.
C. Try test on p. 15; them consult
electrician to provide proper
service.
D. Reset circuit protector on SCM.
E. *
A. Sequence ACCESSORY
switch.
B. Check blower plug on SCM.
C. Check that blower is con-
nected and clamps are secure.
D. Call for Service.
E. Reset circuit protector on
System Control Module.
A. Clean strainer(s).
B. Fill spa to normal level.
C. Tighten fastener.
D. Check for leaks; tighten
clamps and flange bolts.
E. Locate and repair leaks.
F. *
G. *
I. Open Valve.
A. *
17