Jp8: Flash Rom Type - Abit PR5 User Manual

JP8: Flash Chip Type
This jumper is factory set for the type
of Flash Memory Chip installed. The
jumper may not be present on some
boards, with the setting hardwired
on the board instead.

JP8: Flash ROM Type

This jumper is set at the factory for the type of Flash ROM
chip installed. You should not change the setting and it is
shown here for reference only. This jumper may be re-
placed by hardwiring directly onboard on some boards.
There are two types of Flash ROM chip, 5-Volt and 12-
Volt. The chip type has no functional effect. The settings
and location are shown below.
Jumper JP8 Location
JP8 Flash Type
x
Pin 1
x
x
JP8: Flash Memory Chip Type
5-Volt Chip
12-Volt Chip
Note: Jumper may not be present and may be hardwired instead
Pins 1-2 Pins 2-3
Short
Short