Abit SE6 User Manual page 30

3-10
Off: At boot up, the Numeric Keypad is in cursor control mode.
Typematic Rate Setting:
This item allows you to adjust the keystroke repeat rate. When set to Enabled, you can set the two
keyboard typematic controls that follow (Typematic Rate and Typematic Rate Delay). If this item is set to
Disabled, the BIOS will use the default setting. The default setting is Enabled.
Typematic Rate (Chars/Sec):
When you press a key continuously, the keyboard will repeat the keystroke according to the rate you have
set (Unit: characters/second）. Eight options are available: 6 ) 8 ) 10 ) 12 ) 15 ) 20 ) 24 ) 30
) Back to 6. The default setting is 30.
Typematic Delay (Msec):
When you press a key continuously, if you exceed the delay you have set here, the keyboard will
automatically repeat the keystroke according to a certain rate (Unit: milliseconds). Four options are
available: 250 ) 500 ) 750 ) 1000 ) Back to 250. The default setting is 250.
Security Option:
This option can be set to System or Setup. The default setting is Setup. After you have created a password
through PASSWORD SETTING, this option will deny access to your system (System) or modification of
computer setup (BIOS Setup) by unauthorized users.
SYSTEM: When you choose System, a password is required each time the computer boots up. If the
correct password is not given, the system will not start.
SETUP: When you choose Setup, a password is required only when accessing the BIOS Setup. If
you have not set a password in the PASSWORD SETTING option, this option is not
available.
To disable security, select Set Supervisor Password at main menu and then you will be asked to enter the
password. Do not type anything and just press the <Enter> key and it will disable security. Once security
is disabled, the system will boot and you can enter the BIOS setup menu freely
Notice: Don't forget your password. If you forget the password, you will have to open the computer
case and clear all information in the CMOS before you can start up the system. But by doing this, you
will have to reset all previously set options.
OS Select For DRAM > 64MB:
When the system memory is bigger than 64MB, the communication method between the BIOS and the
operating system will differ from one operating system to another. If you use OS/2, select OS2; if you are
using another operating system, select Non-OS2. The default setting is Non-OS2.
Report No FDD For WIN 95:
When using Windows
default setting is No.
SE6
®
95 without a floppy drive, please set this item to Yes. Otherwise, set it to No. The
Chapter3