Abit SE6 User Manual page 13

Installing the Motherboard
(1) ATXPR1: ATX Power Input Connector
If the power supply connectors are not properly
attached to the ATXPR1 power supply, the
power supply or add-on cards may be damaged.
Attach the connector from the power supply to
the ATXPR1 connector here. Remember you
have to push the connector from the ATX power
supply firmly into the ATXPR1 connector,
ensuring that you have a good connection.
Note: Watch the pin position and the orientation
(2A)/(2B)/(2C): FAN1, FAN2 & FAN3 header
Attach the connector from the individual CPU
fan to the header named FAN1. The connector
from the chassis fan should be attached to the
header FAN3 and the connector from the power
fan to FAN2.
You must attach the CPU fan to the processor or
your processor will work abnormally or may be
damaged by overheating.
computer's internal temperature steady and not
too high, connecting the chassis fan is
imperative.
Note: Watch the pin position and the orientation
(3) IR1: IR Header (Infrared)
There is a specific orientation for pins 1 through
5, attach the connector from the IR KIT or IR
device to the IR1 header (left row only). This
motherboard supports standard IR transfer rates.
Note: Watch the pin position and the orientation
(4) WOL1: Wake on LAN Header
If you have a network adapter that supports this
feature, then you can connect the specific cable
from the network adapter to this header. This
feature lets you wake up your computer via
remote control through a local area network.
You may need a specific utility to control the
wake up event, such as the PCnet Magic Packet
2-5
To keep the
User's Manual