Abit SE6 User Manual page 15

Installing the Motherboard
by attaching an optional USB port expansion
cable. There are three ways to use this
additional USB port:
12 14 16 18 20
USB3
2
1
USB2
11
1. For using both two USB ports: Attach the
optional USB port expansion cable to connect
Pin 1~10 on USB2 and USB3 slot.
2. For using one USB port on CNR card: Attach
a jumper to short Pin 5 and 15, Pin 7 and 17.
The additional USB ports plug can be
attached via USB3 (Pin 2, 4, 6, 8, 10, and Pin
12, 14, 16, 18, 20), but there will be only one
USB-port function available.
3. For using one USB port on AGP card: Attach
a jumper to short Pin 6 and 16, Pin 8 and 18.
The additional USB ports plug can be
attached via USB2 (Pin 1, 3, 5, 7, 9 and Pin
11, 13, 15, 17, 19), but there will be only one
USB-port function available.
(9) VL1 Connector
This connector is used for inserting an optional
add-on card to enable the on board VGA to be
output to TV-Out or Flat Panel.
Its function will be unavailable if an external
AGP display card is inserted.
4 6 8 10
3 5 7 9
13 15 17 19
(10) CD1: Internal CD-ROM Drive Audio
Cable Header
This header is for the internal CD-ROM drive
audio cable connection. Please check your audio
cable attached with the CD-ROM drive to see
which type of connector you have and then plug
it into this header.
(11) DIPSW: Front Side Bus Speed Setting
DIP Switch
This switch allows you to manually setting the
front side bus speed.
1 2
DIPSW
On
Off
DIPSW Default Setting
(1) SW1-SW2 "ON", SW3-SW4 "OFF":
Enables you to use the CPU default value
(66/100/133MHz).
(2) SW1-SW2 "OFF", SW8 "ON": Enables
3 4 5 6 7 8
User's Manual
2-7